Outages.io Environment Sensor
Monitor a variety of environmental conditions with history and alerts.
The Outages.io environment sensors comes with one agent and the required sensor for a one time cost of $185.00.
The solution is used with the Outages.io service and can be used with or without Internet monitoring.
- Ambient light: 0 to 30000, units 1 lx.
- Sound/noise: 33.00 to 120.00, units 0.01 dB.
- Temperature: -40.00C to 125.00C, units 0.01 degC.
- Relative humidity: 0.00 to 100.00, units 0.01 %RH.
- Barometric pressure: 300.000 to 1100.000, units 0.001 hPa.
- Discomfort index: 0.00 to 100.00, units 0.01. Expresses the heat and humidity of summer in a quantitative manner. It is calculated from temperature and humidity.
- Heat stroke: -40.00 to 125.00, units 0.01 degC. Expresses the risk of heat stroke in a quantitative manner. It is calculated from temperature and humidity.
- eTVOC: 0 to 32767, units 1 ppb. Equivalent total volatile organic compounds. Average TVOC concentrations between 50 ppb and 325 ppb are considered acceptable but should not peak above 500 ppb.
- eCO2: 400 to 32767, units 1 ppm. Equivalent calculated carbon-dioxide. 350-1,000 ppm concentrations are typical of occupied indoor spaces with good air flow.
- Wall, floor, equipment cabinet and/or earthquakes are recorded, each with their own metrics and combined. Earthquakes will be displayed as separate events in graphic format.
- Vibration count: Accumulated vibration counts with or without earthquake occurring.
- SI value: 0.0 to 6553.5, units 0.1 kine. An index that expresses the effect a certain vibration has on a structure. It has a correlation with seismic intensity. It is calculated from the acceleration values of 2 horizontal axes.
- PGA: 0.0 to 6553.5, units 0.1 gal. Peak acceleration value of a certain interval. It is calculated by resultant acceleration of 2 horizontal axes.
- Seismic intensity: 0.000 to 65.535, units 0.001. A value correlated with seismic intensity that is calculated from the SI value.
Many of the environment metrics can be set to alert if needed.
Simply enable the metric needed then enter either a low or high value or both.
For example, temperature could be set to 10F. If temperature goes below 10F, an alert is sent.
Similarly, temperature could be set to 10F low and 99F high. If temperature goes below or higher than what is set, an alert will be sent out.
Members also have total control over being notified, by email, dashboard alerts, both and SMS is optionally available.